How many cool sculpting treatments will I need for knees, inner and outer thighs? (photos)

Hi.  The best way to know the number of cycles is to have a CS applicator template held up against each area.  A session of 8 applicators will treat all of the areas marked and achieve about a 20% reduction.  Depending upon the thickness of subcutaneous fat, you may wish to have a second session for an additional 20% reduction. Look for a CS University trained provider with multiple machines and the new advantage applicator so that the treatment is more comfortable & shorter.  Best wishes,

Hello,Thank you for your question and pictures. Based on what can be seen it appears that you have been marked appropriately for treatment of the areas that concern you. Legs can always take a little longer to see full results, so you may want to wait a full 3-4 months before progressing to a second round of treatment. You may only need to repeat the saddlebag area, but again, results can always vary. It appears that you are looking at 6 cycles without including your stomach. Please make sure to consult with your local provider to ensure all your questions are answered. Good luck!

The number of CoolSculpting treatments needed varies by individual.  The amount of fat at the starting point and the goals of the patient both can influence how many treatments are needed.  I would say for most of the people I treat, the usual range is 1-3 treatments per area.  

Thank you for submitting your photos along with your questions, this allows me to better address your concern.  You are an IDEAL candidate for Coolsculpting, as you are in good shape and have just a few target concerns.  Remember, this recommendation is limited without a physical exam to properly evaluate your areas of concern.  I would anticipate your inner thighs typically take 2 sessions (with 1 panel on each thigh), performed no later than 4 weeks apart. Your outer thighs may require 1-2 sessions with again probably 1 panel on each thigh.  However, outer thighs can require additional treatment sessions more so than other areas.  I see that your lower abdomen is circled too, for maximum correction of this area, you may require 1-2 panels per session and may desire 2 sessions.  I would recommend undergoing the first treatment session and wait at least 1-2 months to allow your full results to develop and then determine if you wish to undergo another session.  I hope this answer was helpful.

the number of treatments can vary and depends somewhat on what you will be happy with as a final result.. it would probably  take 6 applicators to cover the areas you are looking at and probably at least two treatments on each area . maybe three on some...The cost is determined by how many applicators are used.  usually 600 per applicator so the cost would be about 15 times 600 to get the areas flat or flatter.. it would take about 6 months to see the final result..so a rough estimate would be 9000.  Another alternative is liposuction. all those areas could be treated in one session . it could be done under local anesthesia and would very roughly cost 5000.  

Likely I would say 1-2 cycles each thigh area, knee, and probably 2 cycles abdomen so anywhere from 8-16 cycles total depending on your expectations.

Hi! The best way to find out how many treatments you need is to go to a consultation. They will manipulate the excess body fat and use cool sculpting guides to see how many and what size placements you will need. Just mentioning the areas you want to have treated, if you are a candidate for those areas (meaning enough fat is there to cool sculpt), you would likely need 6+ placements, and possible double treatments to the areas. Coolsculpting is awesome!