10 years ago I had my 370 saline implant swapped for gummy bear silicone with a lift. I now want to downsize from the 36 DD to a small C cup i went for a consultation and the surgeon said it cannot be done. He said the result will be flat and I will be very unhappy Because my nipple is apparently where it should be, and he said he cannot lift and tighten therefore I would have flat on the top. I do not understand this at
Hello, I upsized breast implants from 360cc to 560cc. I was curious to know how difficult it is to downsize breast implants by 200cc with pocket tightening? (no lift) Also is the cost to do so generally a lot more than an initial breast augmentation or are the costs similar if using same surgeon for revision? Additionally, is there more down time required recovery wise since the procedure will involve pocket modification? Thank you
I started as a deflated 34b. Last year, I had a Mod 300cc saline implant. Unfortunately, the resulting size is too large for my lifestyle. Is there a 200cc saline implant that is wide enough for my 12.5 bdw? Silicone is not an option here. Thank you.
Background: 52, 140 pounds. Started with an A cup. First breast augmentation: 360cc UTM brought me to a large B/small C Second breast augmentation: increased to 560cc UTM a year later. I do not like the size. It looks unproportionate on my frame and uneven. Ive attached a photo for reference. How soon after surgery can you downsize? Can I get away with just pocket adjustment maybe an internal bra vs a lift since I started small? Thank you
5.5 1/2, female, 136 pounds Help. I have had4 revisions. The surgeon who was highly rated could not get correc. Asked for small natural look around small C cup. I stared out deflated small B. 1st - left 350, right 330 out of proportion for my body 2nd - left 350, right 330 - still to large 3rd - left 295, right 275 again too large 4th left 295, right 240 - current status. New surgeon suggested over muscle HP, looking at 200 cc lowest hell go. Dont want to hug and fill them
How difficult is it to downsize from 550 cc to 200-300 cc when the implants have already been downsized from 700cc to 550 ( still being too big) a year ago? Will the Breast pockets under the muscle be too large for that small of an implant ? Would a lift help with pocket tightening ? No lift was needed during the previous downsize. Prior to implants I had little breast tissue. Thank you.
I currently have 375cc over the muscle silicone implants. Given my chest diameter, i am a 32E cup in bra size. My back, neck and shoulders hurt. I only wanted to be a full C cup. My question is; how many cc's should i reduce to to get me down closer to a full C. Approx 3 cupp sizes smaller. I dont have much breast tissue at all and my ribcage measurement is 27.07inches. Thank you
I had a breast augmentation on January 4th 2022 and would like to get a revision to downsize as well as correct the asymmetry. I currently have a 700cc Ultra High profile in my left and a 500cc High profile in my right. I would like to downsize the volume to a 350cc and change the profile to a low plus. Could this be accomplished without a lift? I also plan on getting a PRP to address the keloid scars from the incisions underneath my breasts. Thank you in advance!