I had 450cc placed into my breast in December. Two weeks so I had a revision and put it 650cc. I'm 6ft tall so that is why the I plant doesn't look too big. My issue is that my breasts have always been symmetrical and even after the first surgery they sat on the same level. On breast is now sat extremely low and I don't have any breast fold in either breast .they look like cones. I was an a cup before any surgery
I had breast augmentation 12 months ago. I have 450cc silicone. Something about my results feel off to me. Is is symmastia? A bottoming out? I know they are slightly uneven. Please help. I see my surgeon soon and I want to know which concerns to point out to him specifically.
28f, 63kg, 1m 65cm. So i tend to bottom o. I had my first Surgery with only 250cc and it bottomed out. The surgeon fixed it and i had no problems. I went with bigger implants 390cc and it bottomed out on my left boob again and i had a fix. Now almost a year later it seemed like it bottomed out again? Can i just leave it as it is or can something bad happen form from it? I am looking into a new surgeon.
I recently had my old saline implants exchanged for high profile, gummy bear implants along with the capsulectomy in my right breast. I immediately bottomed out. Im wondering what the best option would be for me. I have three different consultations with three different options. 1. Full anchor lift with galaflex 2. Lift at bottom of breast with Strattice 3. Capsulorrhaphy I did not need a lift when I had my implants exchanged but now I have extra skin from bottoming out.
Im mtf trans . I had breast implants 500 cc now its 2yrs for them and in 3 months I seen its double bubble and bottom out Now I need go for 700 cc but can I know if I go for revision can go 700 cc or it definitely has to be less than 500c. ? Also need know What precautions methods doctors use / take when doing revision breast augmentation which had bottom out n double bubble issue before ?
HiI did a breast augmentation surgery 6 months ago but the implant size is too small (motiva 355cc) with barely no projection. dropped significantly and it bottomed down. My surgeon said we can do a revision where she will use mentor implant higher projection because motiva temds to go down more She said she will do internal suture below the breast and on the side to hold the breasts more. Will that work? Will she make bigger incesion to do the side sutures? Will it hurt?
I'm 250/270cc moderate rn and exchanging for bigger because I want more upper pole. My surgeon is deciding with moderate plus and 350 and 385. I don't want to be too much bigger.. just better upper pole. This won't make me MUCH bigger right? I'm also getting pocket tightening and galaflex from bottoming out/lateral displacement
640cc silicone under muscle 2016. Upsized 800cc silicone 2024. Right is sitting lower at incision site & much fuller then right. Much better symmetry before in both size shape n location. What could be going on. Right side implant is not near the incision site. Could I be bottoming out on right side or could left side not be in the pocket or was muscle not fully released. Left is soft. Right is not as soft but not overly firm been on singular for 3 months as a precaution HELP
I feel like one of my breast tissue (shown) has almost separated from the implant if that make sense. From the side you can see where my natural breast tissue ends and the implant keeps going. Is this normal or do I need a revision? Is it just my natural breast anatomy