Get the real deal on beauty treatments—real doctors, real reviews, and real photos with real results.Here's how we earn your trust.
Yes, TruSculpt Flex and ID can be used on the body if you have teeth implants or crowns. As long as the treatment area does not have any metal under the skin and your treating doctor / provider is aware and agrees, it should be fine and without side effects.
Trusculpt FLEX has a positive and a negative terminal and energy passes from one electrode to the next. This would only be an issue if the metal was in the past of the two electrodes and the FLEX is NOT indicated for use on the face.The Trusculpt ID uses monopolar radiofrequency. Two grounding pads are used for 6 treatment pads creating a loop. Again, caution if the metal in the direct area of treatment of the skin and fat. Trusculpt ID is not indicated for use on the face. The neck can also be treated safely with one grounding pad.
There should be no problem with your Trusculpt ID treatment. The energy flows between the electrodes placed on the skin and the grounding pad. This is far from your mouth and won't affect treatment.
Trusculpt ID is contraindicated in implantable electrical devices such as defibrillator and pacemaker. If metal in the body, the Trusculpt ID should be used with caution. Just like a microwave with a metal spoon, heating of the metal is an issue if the focal point of the...
Thank you for your question regarding the 'safe' amount of truSculpt iD treatments that can be done. The benefit on this radio-frequency heat treatment is that it is very safe, quick and effective at fat removal. There can be some concerns about each patient will heal if there...
Both devices kill fat...However, the Trusculpt ID does this faster and with more consistent bulk heating which equates to better response. Trusculpt ID also heats the entire adipose/fat layer where Sculpsure heat may dissipate in deeper layers of the fat. The laser heat on...
Ideally, I would recommend 4-5 applicators for optimal results. Since cost is an issue then I would recommend saving until you are able to afford a full treatment (it may end up saving you money in the end). Best of luck!
Mesh should be below muscle layer and is not metal. It should be fine to undergo Cutera Trusculpt ID. Heat dissipates rapidly in the muscle layer. The key area of concern would be the Trusculpt ID on a significant scar. Avoiding treatment on top of a...
Volume and contouring of the cheeks can be created with well-placed fillers (Voluma, Radiesse, Bellafill) and Sculptra. Implants or fat are alternatives. Botox and radiofrequency can help slim and contour the jawline. Liposuction can help slim the face. Ultherapy, J Plasma and RF treatments c...
