40 yr old I went from a 32D to 32A after my 3 pregnancies. My surgeon says I have some extra skin but good tissue She thinks we can get a good result from implant alone. Measured at 10 cm width and wants to place subfacial above muscle. Im opting for new motiva line which has limited sizing for width. Im wondering should I go w/low moderate 230 cc or if I want higher cc 275 she recommends going moderate high profile to maintain width. I to keep slop shape but also get enough fullness/lift
My name is Anne, I had a breast augmentation 7 months ago. My implants are MOTIVA 220cc, round smoothsilk, base 9.75, projection 4.0. I really wanted to have some cleavage but even wearing push-up bras I cannot get my breasts to come closer together. My question is if by looking at my pictures can you somewhat predict if the same thing would happen when I get bigger implants. I am planning on getting a second BA with no more than 350cc, hoping the gap will be reduced.
I'm interested in getting breast augmentation done. I went to a couple plastic surgeons' office for consultation and touched the normal saline and silicone implants but I don't like feel of them so I did some research and found out about the motiva breast implants that's gaining a lot of popularity. However I'm living in Ontario, CA and I can't seem to find any plastic surgeons here that uses the motiva implants so I'm asking if there are any doctors here that uses the motiva breast implants
I want a very subtle change, where I want to enhance the shape more than the size. I do not want narrow and projecting breasts, but small rounded breasts where the lower pole is fuller. My PS suggested 215 cc medium/demi profile, but I think they looked a bit too big and projecting in the 3D pictures. Will 205 cc low profile be a better choice for me? My PS said that he almost never uses low profile, and that they will be too flat. Im 52 and 132 lbs
Hello! What size do you think i will need to get a similar result to the inspo photos. I really what my breast to look very natural so I am interested in the mini projection. I am 158cm (5'2) and 50kg (100lbs)
I have had a couple of consultations; both surgeons suggested unders with 450cc at the absolute maximum for me. The both mentioned that I have asymmetry. One surgeon said that theyd put Motiva 450cc in the smaller breast and 425cc in the bigger breast. Another surgeon said that hed put 450cc euro silicone in the smaller breast and either 375cc or 400cc in the bigger breast to even them out. Is the difference that noticeable between 375cc and 425cc? Is Motiva or euro silicone better?
Hi, can you give me some advice on choosing the right motiva implnts for correvtion of tubular type 2 breasts please. The dr I had consultation with siggested motica round but I do not like the look of round implants and prefer ergonomix shape, but recently I came across motiva Oval shape ergonomix and was wondering if they are a better option for corrwvtion of tubular breasts since theyre look fullee than regular ergonomix and still not round.
During my consultation I was recommended motiva demi 265cc or mini 230cc. On the 3D scan the Demi implants seem to have more spacing between than the minis.From the size chart I can see that there is actually a 0,25cm difference in diameter. Why was I recommended different diameters for the two projections, shouldnt that measurement stay the same? Will the Demis sit as close together as the minis if I get 285cc with the same diameter?
My bwd is 11cm. The doctor wants to put me on the motiva ergonomix 360cc, which has a diameter of 12.25 cm. How much wider can the implant be placed in relation to my bwd? I don't want to put them that big anyway. 320 cc (11.75cm) would be ideal for me if possible. I am 158cm and 50kg. A cup and I want a small C cup.