I am going in for my breast augmentation 11/15. I'm currently a 36C and would like to be a DDD. Advice?

Question

I picked 600cc I’m 5 7” an 200 pound. I breastfeed all four of my children an have lost a lot of my volume . My current size is a 36 C . When breastfeeding I was a D 36 . I would like to be a DDD I’m going with saline under the muscle .

Jaime S. Schwartz, MD, FACS · Answer

I appreciate your question
After performing hundreds of breast augmentations, I have found that the size of implant best for you is dictated by your chest wall measurements.  Once we determine that we can choose the profile based on what you want or need to achieve.  If you are seeking a natural look, then the diameter of the implant should be equal to or, more ideally, smaller than the width of your breast. The breast width is a measurement of how wide your breast is at the base, which should be measured at the level of the nipple. Choosing an implant that is smaller in diameter than your breast width will avoid the "side breast" fullness that is often associated with a more artificial appearance. Implants that are wider than this can be more palpable, fall more laterally overtime and also be more palpable. After that we will then choose the implant volume based on the measurements and also looking at any asymmetries you might have. You should choose a board certified plastic surgeon that you trust to help guide you in this decision. Bringing photos as well can help us to finalize, but please understand that these are of other peoples bodies and your results will probably be different.
Silicone will give you a fullness at the top (upper pole fullness). Silicone implants come pre-filled with a silicone gel and are the softest implant available. They feel more natural, which makes them a good option for women with less natural breast tissue; but they require a larger incision. It may be more difficult to realize if this type of implant has ruptured, so it is important to monitor them with annual follow-up visits. Additionally, because this implant contains a more softer silicone (less cross-linked), if this implant should rupture, it may leak but only into the scar capsule formed. However, the newer silicone in these implants may not leak even when the implant shell is ruptured. 
Anatomic gummy bear implants might be a good choice to give you a more natural look. These highly-sought-after, anatomic implants offer a look that more closely resembles the natural silhouette of a breast, and, therefore, are a very attractive option for individuals seeking a natural-looking, aesthetic primary breast augmentation. Additionally, these implants are an especially excellent option for patients undergoing restorative or corrective breast surgery because they provide more stability, shape, and reduced incidence of capsular contracture. Compared to other types of silicone gel implants, the silicone in the cohesive gel implant is more cross-linked; therefore, should the implant shell “rupture,” it maintains its shape and silicone does not leak.
 Implants, indifferent projections. The easiest way to think about it is they called me in a low medium and high projection or profile. Most of the time I use the medium profile which gives people the best in terms of natural look as well as a little bit of projection. High profile implants are for someone that wants  A little bit more of a fuller look. Low profile implants are better for someone that really wants a minimal extremely natural augmentation. Depending upon the anatomic versus round implants there are also subtle differences  in terms of the amount of projection for each profile. 
During your breast augmentation consultation, you should feel the different types of implants available, and try on various implant sizers in front of a mirror to help you to get an idea of how you will look following the surgery. You should also bring pictures of the look you would like to achieve, as well as a favorite top to wear when trying on implant sizers. I also use a 3D imaging system to allow you to try on a variety of shapes and sizes. I prefer this method over adding volume due to implants being under the muscle.
We will also discuss the possibility of needing a lift along with an implant. This will depend on the amount of ptosis (nipple position) as it relates to your breast, inframammary crease and chest wall. Needing a lift or not will also determine where to place the scar for the incision.  In some cases if the the breast and nipple is really ptotic (low) it might be best to stage the procedure by performing a lift first and then doing an implant at a second stage. This will also allow you to have a better understanding of the true size and shape of your breast.
In order to limit pain from breast augmentation and speed the recovery process I offer patients Botox into their muscles as well as a long acting numbing medication called exparel. 
The best way to assess and give true advice would be an in-person exam. Please see a board-certified plastic surgeon that specializes in aesthetic and restorative breast surgery.
best of luck!
Dr Schwartz
Board Certified Plastic Surgeon 
#RealSelf100Surgeon
#RealSelfCORESurgeon

Luis A. Mejia, MD · Answer

hello thank you for your question and provided information as well..Based on your question, it is difficult to evaluate if the case does not have photos to give you an official evaluation, my recommendation is that you be evaluated in person by a certified plastic surgeon.

Gary M. Horndeski, MD · Answer

Unfortunately, you have not provided any photographs.  However, 600 cc implants weigh over 1 lb each, are not mechanically stable and you will need a revision.  Since you have breast fed 4 children, your breasts have stretched.  You would benefit from a breast lift more than augmentation.  I recommend The Bellesoma Method to reshape your breast tissue creating upper pole fullness without implants, elevate them higher on the chest wall and more medial to increase your cleavage.  Vertical scars are avoided, nipple sensation and the ability to breast feed are maintained.  At the same time or later, fat transfers can be performed if additional volume is desired.
Best Wishes,
Gary Horndeski, M.D.

Richard G. Reish, MD, FACS · Answer

Hello and thank you for your question.  The
best advice you can receive is from an in-person consultation.  The size, profile, and shape of the
implant is based on your desired breast size/shape, your chest wall
measurements, and soft tissue quality.  This decision should
be based on a detailed discussion with equal input from both you
and your surgeon.   Make sure you specifically look
at before and after pictures of real patients who have had this surgery
performed by your surgeon and evaluate their results.   The most
important aspect is to find a surgeon you are comfortable with. I recommend
that you seek consultation with a qualified board-certified plastic surgeon who
can evaluate you in person.
Best wishes and good luck.
Richard G. Reish, M.D.  FACS
Harvard-trained plastic surgeon

Donovan Rosas, MD · Answer

Patients often think in terms of cup size when considering augmentation. Unfortunately, devices are sized in terms of milliliters (cc) of volume. This can lead to some confusion when sizing. Additionally, it is important to remember that cup size itself is not standardized with variations from one manufacturer to another. Unfortunately, as many women can attest their cup size in an industry leader such as VS is not necessarily transferable to another brand.
Another point which is often under appreciated is that of anatomy and starting point. Any implant will add volume to the volume which is already present. The implant is additive. A particular volume will not necessarily confer the same cup size to different patients (often times it will not even confer the same cup size to different breasts in the same individual...remember they are "sisters" not "twins"). 
A general rule of thumb is that 125cc can represent somewhere between 1/2 to a full cup size increase. Smaller volume differentials (25-50cc) are typically less consequential representing a volume change of less than a shot glass. However, I have found these numbers, at least anecdotally, to be of little help. Patients often present with notions/goals which do not correlate with these sorts of sterile volumetric assessments.
When sizing patients, there are a number of useful tools including:
-3D imaging (has the added benefit of offering a volumetric analysis of the pre-operative breast)
-Breast sizers (rice bags)
-Goal photos
I also recommend that patients commit to a particular look rather than a cup size. Once a patient settles on a look that pleases them the overall cup size increase becomes less relevant.The key to obtaining a natural result is to stay within the parameters defined by your BWD. This will ensure that you avoid the dreaded "fake" look. 
As always, discuss your concerns with a board certified plastic surgeon (ABPS).

I am going in for my breast augmentation 11/15. I'm currently a 36C and would like to be a DDD. Advice?

Answers (10)

Answer: Breast augmentation, 600cc

Answer: Breast augmentation, 600cc

Answer: Sizing advice

Answer: Sizing advice

Recommended reading

Everything you need to know about Breast Implants

Our mission is to create a world where every investment in modern beauty is Worth It.

I am going in for my breast augmentation 11/15. I'm currently a 36C and would like to be a DDD. Advice?

Answers (10)

Answer: Breast augmentation, 600cc

Answer: Breast augmentation, 600cc

Answer: Sizing advice

Answer: Sizing advice

Browse related questions

Recommended reading

Everything you need to know about Breast Implants

Our mission is to create a world where every investment in modern beauty is Worth It.