I hope that everything turned out fine with you. I too had the laser treatment and the white spots that you spoke of were just the pixels of the laser (I think) and should have sloughed off after about 5-6 days. Your skin should be just about perfect by now if you had your procedure done in January!
I don't know about anyone elses experience but my own and all I have to say about Dr. Tomcik and his staff is that they were/are very professional, provided easy to understand information and made double sure that I knew everything about the laser procedure and the recovery I'd chosen to have before they would schedule the procedure.
My procedure (Micro Fractional Co2 Laser) went as planned and I was appreciative of Dr. Tomcik being aggressive with a few of my problem areas. I knew that there would be swelling and itching because his staff prepared me for this. When I called to ask a question about topical benedryl (because my husband was trying to get me to use it) I spoke with Dr. Tomcik personally because he gave me his cell phone number so that he could always be accessable to me as I healed. The issue of the benedryl had been addressed in the literature but we were in the car at the time and so I just called Dr. Tomcik and asked the question. He was very encouraging and reassuring as always.
Whenever I doubted anything about how my healing was progressing I would reread the material that I had been provided and found every answer that I needed such as "how long would the redness last?" The answer was for at least two weeks and then in rare cases it could last for up to 8 weeks.
I know that each persons experience is different but I have been so pleased with Dr. Tomcik and his staff that although I live almost two hours away from San Ramon, I will continue to use Dr. Tomcik as my permanent Dermatologist....he's that good!
Hope that this helps the next person who checks out this site.
Recent comments
Posted to MIXto CO2 Laser BEWARE on 24 Mar 2010
Posted to MIXTO C02 Left White Patches All over my Face!! Help. on 5 Mar 2010
Posted to MIXto CO2 Laser BEWARE on 5 Mar 2010